Nissan Versa (N17): P072E Stuck in 3GR

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P072E Stuck in 3GR

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P072E Stuck in Gear 3 The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more.

- Diagnosis condition

- Shifting is not in progress.

- Stop lamp switch OFF

- Detection conditions

- Deceleration: Less than - 0.35 G

- Gear ratio: 6% or more, or − 6% or less compared with normal gear ratio

 - 2-4 brake solenoid valve

- Control valve assembly

DTC REPRODUCTION PROCEDURE

CAUTION:

  • "TM, "Diagnosis Procedure"" must be performed before starting "DTC CONFIRMATION PROCEDURE".
  • Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
  • Always drive vehicle at a safe speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Drive the vehicle.
  3. Maintain the following conditions for 5 seconds or more.
  4. Check the first trip DTC.

Selector lever : D position (O/D OFF)

Gear : 3GR

Stop lamp switch : OFF

Vehicle speed : 20 km/h (13 MPH) or more

Is "P072E" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.MALFUNCTION CAUSE SIMULATION TEST

Refer to GI, "Intermittent Incident".

Is the check result normal?

YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

P072D Stuck in 2GR

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072D Stuck in Gear 2 The following diagnosis conditions are met an ...

P072F Stuck in 4GR

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072F Stuck in Gear 4 The following diagnosis conditions are met a ...

Other materials:

Uniform tire quality grading
DOT (Department of Transportation) Quality Grades: All passenger car tires must conform to federal safety requirements in addition to these grades. Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 ...

P0507 ISC system
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0171