Nissan Versa (N17): P072F Stuck in 4GR

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P072F Stuck in 4GR

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P072F Stuck in Gear 4 The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more.

- Diagnosis condition

- Shifting is not in progress.

- Stop lamp switch OFF

- Detection conditions

- Deceleration: Less than − 0.35 G

- Gear ratio: 6% or more, or − 6% or less compared with normal gear ratio

 - Low clutch solenoid valve

- Control valve assembly

DTC REPRODUCTION PROCEDURE

CAUTION:

  • "TM, "Diagnosis Procedure"" must be performed before starting "DTC CONFIRMATION PROCEDURE".
  • Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
  • Always drive vehicle at a safe speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn the ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Drive the vehicle.
  3. Maintain the following conditions for 5 seconds or more.
  4. Check the first trip DTC.

Selector lever : D position

Gear : 4GR

Stop lamp switch : OFF

Vehicle speed : 20 km/h (13 MPH) or more

Is "P072F" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.MALFUNCTION CAUSE SIMULATION TEST

Refer to GI, "Intermittent Incident".

Is the check result normal?

YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

P072E Stuck in 3GR

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072E Stuck in Gear 3 The following diagnosis conditions are met a ...

P0731 1GR Incorrect ratio

Description This malfunction is detected when the A/T does not shift into 1GR position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by ...

Other materials:

Fuel level sensor unit, fuel filter and fuel pump assembly
Exploded View 1. Lock ring 2. Fuel level sensor unit, fuel filter and fuel pump assembly 3. O-ring 4. Fuel tank Removal and Installation WARNING: Be sure to read "General Precautions" before working on the fuel system. Refer to FL, "General Precautions". REMOVAL Release t ...

Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0205