DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detection condition | Possible causes |
| P0974 | Shift Solenoid "A" Control Circuit High | The following diagnosis conditions
are met, and the TCM select
switch ON-OFF solenoid
valve monitor value is OFF continuously
for 0.5 seconds or
more. - Diagnosis condition - Select switch ON-OFF solenoid valve: ON - TCM power supply voltage: 10 V < TCM power supply voltage < 16 V |
- Harness or connector
(Select switch ON-OFF solenoid
valve circuit is open or
shorted to power supply) - Select switch ON-OFF solenoid valve |
DTC REPRODUCTION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION

Is "P0974" detected?
YES >> Go to TM, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK CIRCUIT BETWEEN TCM AND A/T UNIT

Is the check result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK SELECT SWITCH ON-OFF SOLENOID VALVE
Check the select switch ON-OFF solenoid valve. Refer to TM, "Component Inspection (Select Switch ONOFF Solenoid Valve)".
Is the check result normal?
YES >> Check intermittent incident. Refer to GI, "Intermittent Incident".
NO >> Repair or replace the malfunctioning parts.
Component Inspection (Select Switch ON-OFF Solenoid Valve)
1.CHECK SELECT SWITCH ON-OFF SOLENOID VALVE
Check the resistance between the A/T unit connector and ground.

Is the check result normal?
YES >> INSPECTION END
NO >> There is a malfunction of select switch ON-OFF solenoid valve. Replace the transaxle assembly.
Refer to TM, "Removal and Installation".
P0973 Shift solenoid ADTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0973 Shift Solenoid "A" Control Circuit Low The following diagnosi ...

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0976 Shift Solenoid B Control Circuit Low The following diagnosis ...
Push starting
CAUTION
Do not push start this vehicle. The
three-way catalyst may be damaged
Continuously Variable Transmission
(CVT) and Manual Transmission models
cannot be push-started or tow-started.
Attempting to do so may cause transmission
damage.
For manual transmission models, never
...
Air cleaner filter
Exploded View
1. Clamp 2. PCV hose 3. Clamp
4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body
7. Grommet 8. Air cleaner filter 9. Air cleaner cover
10. Mass air flow sensor 11. Air duct 12. Clamp
Removal and Installation
REMOVAL
1. Unhook clips (A) and pull the air cleaner cover u ...