Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRETENSIONER"
The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRETENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Manual.
WARNING:
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
PREPARATION
Special Service Tool
The actual shapes of KentMoore tools may from those of special service tools illustrated here.
Tool number (KentMoore No.) Tool name | Description |
KV991J0070
(J45695)
Coolant refill tool
![]() |
Refilling engine cooling system |
EG17650301
(J33984A)
Radiator cap tester adapter
![]() |
Adapting radiator cap tester to radiator cap
and radiator filler neck
a: 28 (1.10) dia.
b: 31.4 (1.236) dia. c: 41.3 (1.626) dia. Unit: mm (in) |
-
(J23688)
Engine coolant refractometer ![]() |
Checking concentration of ethylene glycol in engine coolant |
Commercial Service Tool
Tool name | Description |
Power tool
![]() |
Loosening nuts, screws and bolts |
Radiator cap tester
![]() |
Checking radiator and radiator cap |
Periodical Maintenance Specification ENGINE OIL CAPACITY (APPROXIMATE) & ...
Engine Cooling System M/T models CVT and A/T models Engine Cooling System Schematic M/T models CVT and A/T models OVERHEATING CAUSE ANALYSIS Troubleshooting Chart ...
Body side welt
BODY SIDE WELT : Removal and Installation
CAUTION:
Do not excessively pull or stretch body side welts.
FRONT BODY SIDE WELT
Removal
Remove dash side finisher. Refer to INT "DASH SIDE FINISHER : Removal
and Installation".
Remove center pillar lower finisher. Refer to INT &quo ...
Outside handle
OUTSIDE HANDLE : Removal and Installation
REMOVAL
1. Fully close rear door glass.
2. Remove rear door finisher. Refer to INT "Removal and Installation".
3. Remove sealing screen.
NOTE:
Cut the butyl tape so that some parts of the butyl tape remain on the sealing
screen, if the se ...