The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Manual.
WARNING:
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
- Water soluble dirt:
- Oily dirt:
- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.
- For genuine leather seats, use a genuine leather seat cleaner.
PREPARATION
Special Service Tools
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
1. Rod antenna 2. Antenna base (antenna amp.) 3. Rear door speaker RH (if equipped) 4. Front door speaker RH 5. Front door speaker LH 6. Rear door speaker LH (if equipped) 7. Audio unit
Component Description
SYSTEM
Description The key warning chime does not sound, when all of the following conditions are fulfilled. Key inserted into the key cylinder (key switch signal ON). Ignition switch is in ACC or O ...
AUDIO SYSTEM : System Diagram AUDIO SYSTEM : System Description AUDIO SYSTEM The audio system consists of the following components Audio unit Front door speakers Rear door speakers ...
Fluid cooler tube
Exploded View
1. Fluid cooler tube A 2. Copper sealing washer 3. Fluid cooler tube B
4. Bolt 5. Transaxle assembly
Removal and Installation
WARNING:
Do not open the radiator cap or drain plug when the engine is hot.
There is a danger that hot liquid
may spray out, causing serious in ...
VDC OFF Indicator lamp
Component Function Check
1.CHECK VDC OFF INDICATOR LAMP FUNCTION
Check that VDC OFF indicator lamp in combination meter turns ON for
approximately 2 seconds after ignition
switch is turned ON.
Is the inspection result normal?
YES >> Inspection End.
NO >> Proceed to diagnosis pr ...