Nissan Versa (N17): Precautions

Nissan Versa 2nd generation (N17) Service Manual / Maintenance (MA) / Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.

Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

  • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
  • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
  • Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

  • When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
  • When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service.

PREPARATION

Special Service Tool

The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

Special Service Tool

Commercial Service Tool

Commercial Service Tool

Commercial Service Tool

PERIODIC MAINTENANCE

GPS Antenna

Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI "Removal and Installation" (Type A) or MWI"Removal and Installation" (Type B). 2. Remove the A ...

General maintenance

Explanation of General Maintenance General maintenance includes those items which should be checked during the normal day-to-day operation of the vehicle. They are essential if the vehicle is to c ...

Other materials:

P062F EEPROM
Description TCM compares the calculated value stored in the flash ROM with the value stored in TCM. If the calculated value does not agree with the stored value, TCM judges this as a malfunction. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition ...

G Sensor
Exploded View 1. G sensor  Front Removal and Installation CAUTION: Do not drop or strike G sensor, because it may be damaged by impact. Do not use a power tool. REMOVAL Disconnect the battery negative terminal. Refer to PG "Removal and Installation". Remov ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0091