DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
Is DTC "C1704", "C1705", "C1706", or "C1707" detected?
YES >> Proceed to WT "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK DATA MONITOR
With CONSULT

Is the inspection result normal?
YES >> Inspection End.
NO >> Repair or replace error-detected parts.
Id registration procedureDescription This procedure must be performed after replacing wheels, transmitters or the BCM, or rotating wheels. Work Procedure NOTE: The Signal Tech II Tool (J-50190) can be used to perform t ...
Key warning lamp
Component Function Check
1.CHECK FUNCTION
Select INTELLIGENT KEY of BCM using CONSULT.
Select INDICATOR in ACTIVE TEST mode.
Touch KEY IND or KEY ON to check that it works normally.
Is the inspection result normal?
YES >> Key warning lamp is OK.
NO >> Refer to DLK "Dia ...
Door hinge
DOOR HINGE : Removal and Installation
CAUTION:
Use two people when removing or installing rear door due to its
heavy weight.
When removing and installing rear door assembly, support door
using a suitable tool.
Use shop cloths to protect surrounding components from damage
during rem ...