Nissan Versa (N17): Preparation

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine lubrication system (LU) / Preparation

Special Service Tools

The actual shapes of KentMoore tools may differ from those of special service tools illustrated here.

Tool number (KentMoore No.) Tool name	Description
ST25051001 (J256951) Oil pressure gauge	Measuring oil pressure Maximum measuring range: 2,452 kPa (225 kgcm2, 356 psi)
ST25052000 (J256952) Hose	Adapting oil pressure gauge to cylinder block
KV10115801 (J38956) Oil filter wrench	Removing oil filter a: 64.3 mm (2.531 in)
KV10111100 (J37228) Seal cutter	Removing steel oil pan and rear timing chain case
WS39930000 ( - ) Tube presser	Pressing the tube of liquid gasket

Commercial Service Tools

Tool name	Description
Deep socket	Removing and installing oil pressure switch 27 mm (1.06 in)
Power tool	Loosening nuts, screws and bolts

DESCRIPTION

Engine Lubrication System

Engine Lubrication System

Engine Lubrication System Schematic

Engine Lubrication System Schematic

Engine oil

Inspection ENGINE OIL LEVEL Park vehicle on a level surface, wait 10 minutes before checking the engine oil level. Pull out oil level gauge and wipe it clean. Insert oil level gauge and ma ...

Other materials:

G Sensor
Exploded View 1. G sensor Front Removal and Installation CAUTION: Do not drop or strike G sensor, because it may be damaged by impact. Do not use a power tool. REMOVAL Disconnect the battery negative terminal. Refer to PG "Removal and Installation". Remov ...

C1607, C1608 EPS Control unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2 ...

Nissan Versa (N17): Preparation

Precautions

Engine oil

Other materials:

Categories