OUTSIDE HANDLE : Removal and Installation
REMOVAL
1. Remove the outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
2. Remove the handle cover screw, handle cover and door antenna.

INSTALLATION
Installation is in the reverse order of removal.
REAR BUMPER : Removal and Installation
REMOVAL
1. Remove the rear bumper fascia. Refer to EXT "Removal and Installation".
2. Remove clips (A) and the outside key antenna (rear bumper) (1).

INSTALLATION
Installation is in the reverse order of removal.
INTELLIGENT KEY WARNING BUZZER
Removal and Installation
REMOVAL
Remove bolt (A) and the Intelligent Key warning buzzer (1).

INSTALLATION
Installation is in the reverse order of removal.
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
REMOVAL
1. Remove the glove box. Refer to IP "Removal and Installation".
2. Remove the remote keyless entry receiver bolt (A).
3. Disconnect the harness connector from remote keyless entry receiver and remove remote keyless entry receiver (1)

INSTALLATION
Installation is in the reverse order of removal.

Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a suitable tool (A) wrapped with a cloth into the slit of the corner ...
Fuel filler cap warning system
FUEL FILLER CAP WARNING SYSTEM : System Diagram
FUEL FILLER CAP WARNING SYSTEM : System Description
INPUT/OUTPUT SIGNAL CHART
Input
Unit/Sensor
Input signal to ECM
ECM function
EVAP control system pressure sensor
Pressure in purge line
Fuel filler cap warning cont ...
P0506 ISC system
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...