Nissan Versa (N17): Remote keyless entry receiver

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Remote keyless entry receiver

Removal and Installation

REMOVAL

1. Remove the glove box. Refer to IP "Removal and Installation".

2. Remove the remote keyless entry receiver bolt (A).

3. Disconnect the harness connector from remote keyless entry receiver and remove remote keyless entry receiver (1)

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Door switch

Exploded View 1. Door switch 2. Door switch bolt Removal and Installation REMOVAL 1. Remove the door switch bolt (A). 2. Disconnect the harness connector from door switch (1) and remove. ...

Keyfob battery

Removal and Installation REPLACEMENT 1. Remove screw from the rear of keyfob. 2. Place the key with the lower case facing up. Use a suitable tool wrapped with tape between upper case and lower c ...

Other materials:

Seat belt warning system
Seat Belt Warning System Does Not Function 1.SEAT BELT WARNING LIGHT Turn ignition switch ON. Does the seat belt warning lamp come ON? YES >> GO TO 2 NO >> Check 10A fuse [No. 3, located in the fuse block (J/B)]. Check seat belt buckle switch LH. Check harness between combi ...

Refrigerant pressure sensor
Removal and Installation CAUTION: Perform oil return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or oil is detected, do not perform oil return operation. Refer to HA "Perform Oil Return Operation". REMOVAL Use refrigerant ...

Nissan Versa (N17): Remote keyless entry receiver

Door switch

Keyfob battery

Other materials:

Categories