Exploded View
1. Piston rod lock nut 2. Washer 3. Bushing 4. Distance tube 5. Bound bumper cover 6. Bound bumper 7. Shock absorber assembly 8. Rear suspension beam
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
INSPECTION AFTER REMOVAL
Shock Absorber
Check the following items, and replace the part if necessary.
Bound Bumper, Bushing
Check for cracks and damage. Replace it if necessary.
Washer, Bound Bumper Cover, Distance Tube
INSPECTION AFTER INSTALLATION
Check wheel alignment. Refer to RSU "Inspection".
CAUTION:
NOTE:
(A) : 20 - 30 mm (0.79 - 1.18 in)
3. Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION: Dispose of drained oil according to the law and local regulations.
Inspection DESCRIPTION CAUTION: The adjustment mechanisms of camber and toe-in are not included. If camber and toe-in is outside the standard, check front suspension parts for wear and dama ...
Exploded View 1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Rear suspension beam Removal and Installation REMOVAL Remove the wheel and tire assemblies using power tool. Refe ...
Vehicle loading information
WARNING
It is extremely dangerous to ride
in a cargo area inside a vehicle. In
a collision, people riding in these
areas are more likely to be seriously
injured or killed.
Do not allow people to ride in any
area of your vehicle that is not
equipped with seats and seat
belts.
Be ...
Accelerator control system
Exploded View
1. Accelerator pedal assembly 2. Brake pedal bracket A. Locating hook
B. Locating pin
Removal and Installation
CAUTION:
Do not disassemble accelerator pedal assembly. Do not remove
accelerator pedal position sensor
from accelerator pedal assembly.
Avoid impact from ...