Nissan Versa (N17): Trunk room lamp

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Interior lighting system (INL) / Trunk room lamp

Exploded View

Exploded View

1. Trunk room lamp 2. Bulb Front Pawl

Removal and Installation

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

  • Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
  • Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirt or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.

REMOVAL

1. Release the trunk room lamp pawl to open lens.

: Pawl

REMOVAL

2. Remove the bulb.

3. Release trunk room lamp pawl with a suitable tool (A)

Pawl

Front

4. Disconnect harness connector from trunk room lamp and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

  • Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
  • Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirt or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.

TRUNK ROOM LAMP BULB

Removal

1. Release the trunk room lamp pawl to open lens.

Pawl

REMOVAL

2. Remove the bulb.

Installation

Installation is in the reverse order of removal.

ILLUMINATION CONTROL SWITCH

Removal and Installation

The illumination control switch is integrated in the combination meter. Refer to MWI "Removal and Installation" (TYPE A) or MWI "Removal and Installation" (TYPE B).

SERVICE DATA AND SPECIFICATIONS (SDS)

Bulb Specifications

*: Always check with the Parts Department for the latest parts info.

Console lamp

Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", us ...

Other materials:

A/T Control system
A/T Control system : component parts location 1. IPDM E/R 2. TCM 3. Transmission range switch 4. A/T unit 5. Output speed sensor 6. Stop lamp switch 7. A/T shift selector 8. Overdrive control switch 9. Combination meter (type B) A/T Control system : component description Name ...

Low tire pressure warning lamp does not turn off
Diagnosis Procedure 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace damaged parts. 2.BCM POWER SUPPLY AND GROUND CIRCUITS ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0344