Exploded View

1. Flywheel 2. Clutch disc 3. Clutch cover
4. Input shaft A. First step B. Final step
: Apply lithium-based grease
including molybdenum disulphide.
CAUTION:
REMOVAL
INSTALLATION
CAUTION: Be sure to apply grease to the points specified. Otherwise, noise, poor disengagement, or damage to the clutch may result. Excessive grease may cause slip or shudder. If grease adheres to seal of CSC, it may cause clutch fluid leakage. Wipe off excess grease. Wipe off any grease oozing from the parts.

INSPECTION AFTER REMOVAL
Clutch Disc
Runout limit/diameter of the area to be measured : Refer to CL, "Clutch Disc".
Maximum allowable spline backlash (at outer edge of disc) : Refer to CL, "Clutch Disc".
Facing wear limit (depth to the rivet head) (A) : Refer to CL, "Clutch Disc".


Clutch Cover
NOTE:
- Worn thrust ring will generate a beating noise when tapped at the rivet using suitable tool.
- Broken thrust ring will make a clinking sound when cover is shaken up and down.
INSPECTION AFTER INSTALLATION
Clutch Cover
Check diaphragm spring levers for unevenness with the clutch cover installed on the engine. If they exceed the tolerance, adjust diaphragm spring lever height, using Tool (A).
Tolerance for diaphragm spring lever unevenness : Refer to CL-21, "Clutch Cover".
Tool number : ST20050240 ( - )

CSC (Concentric slave cylinder)Exploded View 1. Transaxle assembly 2. CSC (concentric slave cylinder) Removal and Installation CAUTION: Do not reuse CSC (concentric slave cylinder). CSC slides back to the original po ...

General Specifications Engine type HR16DE Type of clutch control Hydraulic Clutch disc Facing size (Outer dia. × Inner dia. × Thickness) 200 &time ...
Cleaning exterior
In order to maintain the appearance of your vehicle,
it is important to take proper care of it.
To protect the paint surfaces, please wash your
vehicle as soon as you can:
After a rainfall to prevent possible damage
from acid rain.
After driving on coastal roads.
When contaminants suc ...
Fuel level sensor unit
Disassembly and Assembly
Fuel Level Sender Unit
1. Harness connectors 2. Level sending unit module 3. Fuel temperature sensor
4. Float arm assembly
Disassembly
NOTE:
Before disassembly, note the proper placement of the wires to the correct
terminals and correct wire routing to
the term ...