Idle Speed

*: Under the following conditions
Ignition Timing

*: Under the following conditions
Calculated Load Value

Mass Air Flow Sensor

*: Engine is warmed up to normal operating temperature and running under no load.
Removal and installationECM Exploded View 1. ECM bracket 2. ECM : Vehicle front Removal and Installation CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to EC-122, "Work Procedure". ...
Fuel level sensor unit
Disassembly and Assembly
Fuel Level Sender Unit
1. Harness connectors 2. Level sending unit module 3. Fuel temperature sensor
4. Float arm assembly
Disassembly
NOTE:
Before disassembly, note the proper placement of the wires to the correct
terminals and correct wire routing to
the term ...
ABS Actuator and electric unit
(control unit)
Exploded View
1. ABS actuator and electric unit (control
unit)
2. ABS actuator and electric unit (control
unit) harness connector
3. Bushing
4. Bracket A. To master cylinder secondary side B. To master cylinder primary
side
C. To front wheel cylinder (LH) D. To rear wheel cylinder (RH ...