Nissan Versa (N17): Service data and specifications (SDS)

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Service data and specifications (SDS)

General Specification  

CAUTION:

  • Use only Genuine NISSAN Matic S ATF. Do not mix with other ATF.
  • Using ATF other than Genuine NISSAN Matic S ATF will cause deterioration of driveability and A/T durability, and may damage the A/T, which is not covered by the warranty.

*1: Refer to MA "Fluids and Lubricants".

*2: The fluid capacity is the reference value.

Vehicle Speed at Which Gear Shifting Occurs  

  • At half throttle, the accelerator opening is 4/8 of the full opening.

Vehicle Speed at Which Lock-up Occurs/Releases 

  • At closed throttle, the accelerator opening is less than 1/8 condition. (Closed throttle position signal OFF)
  • At half throttle, the accelerator opening is 4/8 of the full opening.

Stall Speed

Stall speed

2,410 - 2,850 rpm

Line Pressure

Torque Converter

Dimension between end of converter housing and torque converter

16.2 mm (0.638 in)

Transmission assembly

Exploded View 1. Transaxle assembly A. : Tightening must be done following the installation procedure. Refer to TM "Removal and Installation". ...

Other materials:

Final drive
Exploded View 1. Differential side bearing outer race 2. Differential side bearing 3. Final drive : Replace the parts as a set. Disassembly Remove differential side bearings, using Tool (A) and suitable tool. Tool number : ST33052000 ( - ) Assembly Install differential sid ...

U0300 Can communication data
Description The amount of data transmitted from each control unit is read. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0300 Internal Control Module Software Incompatibility When the amount of data transmitt ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0089