Removal and Installation
REMOVAL
a. Remove steering column cover screws (A).
b. Tilt the steering column to the lowest position.
c. Pull steering column upper cover (1) upward to disengage steering column upper cover pawls.
: Pawl
d. Remove steering column upper cover.
e. Pull steering column lower cover (2) downward to remove.

INSTALLATION
Installation is in the reverse order of removal.
Instrument panel assemblyExploded View 1. Instrument side finisher (RH) 2. Passenger air bag module 3. Instrument panel assembly 4. Instrument side finisher (LH) 5. Ventilator grilles (LH) 6. Combination meter 7. C ...

Removal and Installation REMOVAL Remove steering column covers. Refer to IP "Removal and Installation". Remove cluster lid C. Refer to IP "Removal and Installation". Remov ...
Wiper and washer switch
Switch operation
Type A (if so equipped)
The windshield wiper and washer operates when
the ignition switch is in the ON position.
Push the lever down to operate the wiper at the
following speed:
Intermittent (INT) - intermittent operation
can be adjusted by turning the knob toward
...
Fluid cooler & fluid warmer system
FLUID COOLER & FLUID WARMER SYSTEM :
System Description
CVT FLUID COOLER SCHEMATIC
COMPONENT DESCRIPTION
CVT Oil Warmer
The CVT oil warmer (1) is installed on the front part of transaxle
assembly.
When engine is started while engine and CVT are cold, engine
coolant temperatur ...