Removal and Installation
REMOVAL

Pawl
Metal clip
a. Remove combination meter finisher and cluster lid A as an assembly by pulling rearward to release pawls and metal clips.
b. Separate cluster lid A (2) from combination meter finisher (1) by releasing the metal clips (If necessary).
INSTALLATION
Installation is in the reverse order of removal.
Steering column coversRemoval and Installation REMOVAL Remove instrument lower panel LH. Refer to IP "Removal and Installation". Remove lower knee protector (LH) bolts and lower knee protector (LH). ...

Removal and Installation REMOVAL Remove data link connector from instrument lower panel LH. Remove hood and fuel filler handle assembly bolts (A) and position hood and fuel filler handle as ...
When traveling or registering in another country
When planning to drive your NISSAN vehicle
in another country, you should first find
out if the fuel available is suitable for your vehicle's
engine.
Using fuel with an octane rating that is too low
may cause engine damage. All gasoline vehicles
must be operated with unleaded gasoline. There ...
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the tire sidewall between tread shoulder and
maximum section width. For example:
Treadwear 200 ...