Nissan Versa (N17): Steering wheel

Nissan Versa 2nd generation (N17) Service Manual / Steering / Steering system (ST) / Steering wheel

Exploded View

Exploded View

1. Steering wheel

Removal and Installation

REMOVAL

NOTE: When reconnecting spiral cable, secure cable with a tape so that case and rotating part stay aligned. This will omit neutral position alignment procedure during spiral cable installation.

  1. Set vehicle to the straight-ahead position.
  2. Remove driver air bag module. Refer to SR "Removal and Installation".
  3. Remove steering wheel lock nut after steering is locked.
  4. Remove steering wheel using a suitable tool (A).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

  • Check the spiral cable neutral position after replacing or rotating spiral cable. Refer to SR "Removal and Installation".

CAUTION:

  • Do not twist spiral cable excessively after it becomes tight. (Twisting may cause the cable to be torn off.)
  • Do not reuse steering wheel lock nut.

Steering wheel

Inspection CHECKING CONDITION OF INSTALLATION Check installation conditions of steering gear assembly, front suspension assembly, axle and steering column assembly. Check if movement exis ...

Steering column

Exploded View 1. Steering column assembly 2. Clamp ...

Other materials:

Starting the engine (models with NISSAN Intelligent Key system)
1. Apply the parking brake. 2. Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate if the shift lever is in any of the driving positions. 3. Push the ignition switch to the ON position. Depress the brake pedal and push the ...

Valve oil seal
VALVE OIL SEAL : Removal and Installation REMOVAL Remove camshafts. Remove valve lifters. Rotate crankshaft, and set piston with valve oil seal to be removed to TDC. This will prevent the valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0102