Nissan Versa (N17): System

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / Power control system (PCS) / System

RELAY CONTROL SYSTEM

RELAY CONTROL SYSTEM : System Diagram

RELAY CONTROL SYSTEM : System Diagram

RELAY CONTROL SYSTEM : System Description

IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from various sensors and the request signals received from control units via CAN communication.

CAUTION: To prevent damage to the parts, IPDM E/R integrated relays cannot be removed.

RELAY CONTROL SYSTEM : System Description

POWER CONSUMPTION CONTROL SYSTEM

POWER CONSUMPTION CONTROL SYSTEM : System Diagram

POWER CONSUMPTION CONTROL SYSTEM : System Diagram

POWER CONSUMPTION CONTROL SYSTEM : System Description

OUTLINE

  • IPDM E/R incorporates a power consumption control function that reduces the power consumption according to the vehicle status.
  • IPDM E/R changes its status (control mode) with the sleep wake up signal received from BCM via CAN communication.

Normal mode (wake-up)

  • CAN communication is normally performed with other control units.
  • Individual unit control by IPDM E/R is normally performed.

Low power consumption mode (sleep)

  • Low power consumption control is active.
  • CAN transmission is stopped.

SLEEP MODE ACTIVATION

  • IPDM E/R judges that the sleep-ready conditions are fulfilled when the ignition switch is OFF and none of the conditions below are present. Then it transmits a sleep-ready signal (ready) to BCM via CAN communication.
  • Outputting signals to actuators
  • Switches or relays operating
  • Output requests are being received from control units via CAN communication.
  • IPDM E/R stops CAN communication and enters the low power consumption mode when it receives a sleep wake up signal (sleep) from BCM and the sleep-ready conditions are fulfilled.

WAKE-UP OPERATION

  • IPDM E/R changes from the low power consumption mode to the normal mode when it receives a sleep wake-up signal (wake up) from BCM or any of the following conditions is fulfilled. In addition, it transmits a sleep-ready signal (not-ready) to BCM via CAN communication to report the CAN communication start.
  • Ignition switch ON
  • An output request is received from a control unit via CAN communication.

Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", us ...

Diagnosis system (IPDM E/R)

Diagnosis Description AUTO ACTIVE TEST Description In auto active test, the IPDM E/R sends a drive signal to the following systems to check their operation. Front wiper (LO, HI) Parking l ...

Other materials:

If your vehicle overheats
If your vehicle is overheating (indicated by an extremely high temperature gauge reading (if so equipped), a red high temperature warning light (if so equipped) ), or if you feel a lack of engine power, detect abnormal noise, etc. take the following steps. WARNING Do not continue to driv ...

Fuel pressure check
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform "FUEL PRESSURE RELEASE" in "WORK SUPPORT" mode with CONSULT. Start engine. After engine stalls, crank it two or three times to release all fuel pressure. Turn ignition switc ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0061