Nissan Versa (N17): The oil pressure warning lamp does not turn on

Nissan Versa 2nd generation (N17) Service Manual / Driver information & multimedia / Meter, warning lamp & indicator (MWI) / The oil pressure warning lamp does not turn on

Description

The oil pressure warning lamp stays OFF when the ignition switch is turned ON.

Diagnosis Procedure

1.CHECK COMBINATION METER OIL PRESSURE WARNING LIGHT

1. Select METER/M&A on CONSULT.

2. Observe OIL W/L DATA MONITOR while operating the ignition switch.   

Is the inspection result normal?

YES >> Inspection end.

NO >> Replace combination meter. Refer to MWI "Removal and Installation".

THE OIL PRESSURE WARNING LAMP DOES NOT TURN OFF

Description

The oil pressure warning lamp remains on while the engine is running (normal oil pressure).

Diagnosis Procedure

1.CHECK COMBINATION METER INPUT SIGNAL

1. Start the engine and select METER/M&A on CONSULT.

2. Observe OIL W/L DATA MONITOR and the operation of the oil pressure warning lamp on the combination meter.                                           

Is the inspection result normal?

YES >> Perform ECM self-diagnosis. Refer to EC "CONSULT Function".

NO >> Replace combination meter. Refer to MWI "Removal and Installation".

The fuel gauge indicator does not operate

Description Fuel gauge will not indicate from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL 1. Select METER/M&A on CONSULT. 2. Using "DATA MONITOR, compare ...

The low washer fluid warning continues displaying, or does not display

Description The warning is still displayed even after washer fluid is added. The warning is not displayed even though the washer tank is empty. Diagnosis Procedure 1.CHECK WASHER FLUID L ...

Other materials:

Drive belt idler pulley
Exploded View 1. Generator bracket 2. Center shaft 3. Spacer 4. Adjusting bolt 5. Washer 6. Idler pulley 7. Plate Removal and Installation REMOVAL Remove the fender protector (RH). Remove the air duct inlet assembly. Remove drive belt. Remove the lock nut, and then remove the pl ...

P0712 Transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0712 Transmission Fluid Temperature Sensor "A" Circuit Low Under the following diagnosis conditions, the A/T fluid temperature identified by TCM is 180C (3 ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0057