Nissan Versa (N17): The parking brake release warning continues sounding, or does not sound

Nissan Versa 2nd generation (N17) Service Manual / Driver information & multimedia / Warning chime system (WCS) / The parking brake release warning continues sounding, or does not sound

Description

  • The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released.
  • The parking brake warning buzzer does not sound at all even though driving the vehicle with the parking brake applied.

Diagnosis Procedure

NOTE: To identify combination meter type, refer to MWI "Information" or MWI "Information".

1.CHECK PARKING BRAKE WARNING LAMP

1. Start the engine.

2. Check the operation of the brake warning lamp by operating the parking brake.

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation" (Type A) or MWI "Removal and Installation" (Type B).

NO >> GO TO 2.

2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

Perform check for the parking brake switch signal circuit. Refer to WCS "TYPE B : Diagnosis Procedure" or WCS "TYPE A : Diagnosis Procedure".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair harness or connector.

3.CHECK PARKING BRAKE SWITCH

Perform a component inspection of the parking brake switch. Refer to WCS "TYPE B : Component Inspection" or WCS "TYPE A : Component Inspection".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation" (Type A) or MWI "Removal and Installation" (Type B).

NO >> Replace parking brake switch. Refer to PB "Exploded View".

The seat belt reminder warning continues sounding, or does not sound

Description Seat belt reminder warning does not sound. Seat belt reminder warning sounds continuously. Diagnosis Procedure NOTE: To identify combination meter type, refer to MWI "Infor ...

Other materials:

Timing chain
Exploded View 1. Timing chain slack guide 2. Timing chain tensioner 3. Camshaft sprocket (EXH) 4. Camshaft sprocket (INT) 5. Plug 6. Front oil seal 7. Crankshaft pulley 8. Crankshaft pulley bolt 9. Front cover 10. Crankshaft sprocket 11. Crankshaft sprocket key 12. Oil pump sprocket 13. O ...

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 2,400 rpm under no load (for example, the shift lever position is neutral and engine speed is over 2,400 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies ba ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0075