Component Function Check
1.CHECK FUNCTION
Press the trunk release button on the keyfob and check that the trunk lid opens.
Is the inspection result normal?
YES >> Inspection End.
NO >> Refer to DLK "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to DLK "Wiring Diagram".
1.CHECK TRUNK LID OPENER ACTUATOR SIGNAL
Check voltage between BCM connector M19 terminal 53 and ground.
Is the inspection result normal?
YES >> GO TO 3
NO >> GO TO 2
2.CHECK TRUNK LID OPENER ACTUATOR CIRCUIT
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> Repair or replace harness.
3.CHECK TRUNK LID OPENER ACTUATOR GROUND CIRCUIT
Check continuity between trunk lid lock assembly connector B51 terminal 2 and
ground.
Is the inspection result normal?
YES >> Replace trunk lid lock assembly.
NO >> Repair or replace harness.
Description Receives keyfob operation and transmits to BCM. ...
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRETENSIONER"
The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT
PRETENSIONER", used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and f ...
C1145, C1146 Yaw rate/side/decel g
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
Turn ignition switch OFF to ON.
Perform self diagnostic result.
Is DTC C1145 or C1146 detected?
YES >> Proceed to diagnosis procedure. Refer to BRC "Diagn ...