TRUNK LID OPENER HANDLE : Removal and Installation
REMOVAL
1. Remove front kicking plate (LH). Refer to INT "KICKING PLATE INNER : Removal and Installation".
2. Release pawl using a suitable tool (A) and open the harness clip.
Pawl

3. Position floor carpet aside as necessary to access the trunk lid opener handle bolts.
4. Remove the trunk lid opener handle bolts.
5. Remove trunk lid opener cable from trunk lid opener handle.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Trunk lid lockTRUNK LID LOCK : Removal and Installation REMOVAL 1. Remove trunk lid finisher (If equipped). Refer to INT "Removal and Installation". 2. Disengage rod holder (1) by lifting upward, and ...

TRUNK LID OPENER CABLE : Removal and Installation REMOVAL 1. Remove trunk lid striker. Refer to DLK "TRUNK LID STRIKER : Removal and Installation". 2. Remove trunk side finisher (LH). R ...
Recommended fluids/lubricants and capacities
The following are approximate capacities. The actual refill capacities may
be a little different. When refilling, follow the procedure
described in the "Do-it-yourself" section to determine the proper refill
capacity.
...
Front wiper motor ground circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW "Wiring Diagram".
1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect front wiper motor.
3. Check continuity between front wiper motor harness connector and ground.
Is the inspe ...