Nissan Versa (N17): Trunk lid striker

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid striker

TRUNK LID STRIKER : Removal and Installation

REMOVAL

1. Remove trunk rear plate. Refer to INT "TRUNK REAR PLATE : Removal and Installation".

2. Remove trunk lid opener cable bolt (A) and trunk lid striker bolts (B).

REMOVAL

3. Remove trunk lid striker (1), disconnect trunk lid opener cable (2) from trunk lid striker and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

After installation, check trunk lid open/close, lock/unlock operation.
After installation, perform the trunk lid adjustment procedure. Refer to DLK "TRUNK LID ASSEMBLY : Adjustment".

Trunk lid hinge

TRUNK LID HINGE : Removal and Installation REMOVAL 1. Remove harness clips (A) from trunk lid hinge (RH only) (1). 2. Remove trunk lid assembly. Refer to DLK "TRUNK LID ASSEMBLY : Removal ...

Other materials:

When traveling or registering in another country
When planning to drive your NISSAN vehicle in another country, you should first find out if the fuel available is suitable for your vehicle's engine. Using fuel with an octane rating that is too low may cause engine damage. All gasoline vehicles must be operated with unleaded gasoline. There ...

Emission control system warranty
Your NISSAN vehicle is covered by the following emission warranties: For USA 1. Emission Defects Warranty 2. Emissions Performance Warranty Details of this warranty may be found with other vehicle warranties in your Warranty Information Booklet which comes with your NISSAN vehicle. If you ...

Nissan Versa (N17): Trunk lid striker

Trunk lid assembly

Trunk lid hinge

Other materials:

Categories