Nissan Versa (N17): U1000 CAN Comm circuit

Nissan Versa 2nd generation (N17) Service Manual / Brakes / Brake control system (BRC) / U1000 CAN Comm circuit

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1.CHECK DTC DETECTION

With CONSULT.

  1. Turn ignition switch ON.
  2. Perform self diagnostic result.

Is DTC U1000 detected?

YES >> Proceed to diagnosis procedure. Refer to LAN "Trouble Diagnosis Flow Chart".

NO >> Refer to GI "Intermittent Incident".

C1164, C1165, C1166, C1167 CV/SV System

U1002 System comm (CAN)

Other materials:

Keyfob battery
Removal and Installation REPLACEMENT 1. Remove screw from the rear of keyfob. 2. Place the key with the lower case facing up. Use a suitable tool wrapped with tape between upper case and lower case and separate the lower case from the upper case. CAUTION: Do not touch the circuit board or ...

ECM Branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES > ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0065