Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW "Wiring Diagram".
1. CHECK FRONT WASHER MOTOR FUSE
1. Turn the ignition switch OFF.
2. Check that the following fuse is not blown.
Is the fuse blown?
YES >> Replace the fuse after repairing the affected circuit.
NO >> GO TO 2.
2. CHECK FRONT WASHER MOTOR POWER SUPPLY
1. Disconnect front washer motor.
2. Turn ignition switch ON.
3. Check voltage between front washer motor harness connector and ground.
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair harness between fuse and front washer motor.
3. CHECK FRONT WASHER MOTOR GROUND CIRCUIT
Check continuity between front washer motor harness connector and ground
while operating washer switch.
Is the inspection result normal?
YES >> Replace front washer motor. Refer to WW "Removal and Installation".
NO >> GO TO 4.
4. CHECK WASHER SWITCH
Check washer switch. Refer to WW "Component Inspection".
Is the inspection result normal?
YES >> Repair harness between front washer motor washer switch.
NO >> Replace washer switch. Refer to WW "Removal and Installation".
Front wiper motor ground circuitDiagnosis Procedure Regarding Wiring Diagram information, refer to WW "Wiring Diagram". 1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect front wip ...

Description Washer switch is integrated with combination switch. Washer switch supplies ground for the front washer motor. Component Inspection 1. CHECK WASHER SWITCH 1. Turn the igniti ...
Air pressure monitor
AIR PRESSURE MONITOR : CONSULT Function
(BCM - AIR PRESSURE MONITOR)
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure ...
Body side welt
BODY SIDE WELT : Removal and Installation
CAUTION:
Do not excessively pull or stretch body side welts.
FRONT BODY SIDE WELT
Removal
Remove dash side finisher. Refer to INT "DASH SIDE FINISHER : Removal
and Installation".
Remove center pillar lower finisher. Refer to INT &quo ...