WIPER BLADE : Removal and Installation
REMOVAL
1. Lift up wiper arm and set to the position where wiper arm can be locked back.
2. Press and hold lever (A) of wiper blade (1). Pull in the direction indicated by the arrow as shown and remove wiper blade from wiper arm (2).
CAUTION: Wrap wiper arm using a shop cloth so that wiper blade does not damage windshield glass.
INSTALLATION
Installation is in the reverse order of removal.
WIPER REFILL : Removal and Installation REMOVAL 1. Remove wiper blade from the wiper arm. Refer to WW "WIPER BLADE : Removal and Installation". 2. From portion (A) of wiper refill (1), ...
U0140 Lost communication (BCM)
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
U0140
Lost Communication With Body
Control Module
When the ignition switch is ON,
TCM is unable to receive the
CAN communications signal
from BCM continuously ...
Line pressure test
Work Procedure
INSPECTION
Check the engine oil level. Replenish if necessary. Refer to LU
"Inspection".
Check for CVT fluid leaks. Refer to TM "Inspection".
Drive for about 10 minutes to warm up the vehicle so that the CVT fluid
temperature is 50 to 80C (122 to
...