Nissan Versa

 Sedan Service Manual

Transmission & driveline » Transaxle & transmission (TM) » Precautions
Removal and Installation Procedure for A/T Assembly Connector

REMOVAL

Rotate bayonet ring (A) counterclockwise. Pull out A/T assembly harness connector (B) upward and remove it.

INSTALLATION

1. Align marking (A) on A/T assembly harness connector terminal body with marking (B) on bayonet ring. Insert A/T assembly harness connector. Then rotate bayonet ring clockwise.

2. Rotate bayonet ring clockwise until marking (A) on A/T assembly harness connector terminal body is aligned with the slit (B) on bayonet ring as shown in the figure (correctly fitting condition).

Install A/T assembly harness connector to A/T assembly harness connector terminal body.

CAUTION:

• Securely align marking (A) on A/T assembly harness connector terminal body with bayonet ring slit (B). Then, be careful not to make a half fit condition as shown in the figure.
• Do not mistake the slit of bayonet ring for other dent portion.

Service Notice or Precaution

OBD SELF-DIAGNOSIS

• A/T self-diagnosis is performed by the TCM in combination with the ECM. The results can be read through the blinking pattern of the A/T CHECK indicator or the malfunction indicator Lamp (MIL). Refer to the table on "SELF-DIAGNOSTIC RESULTS" for the indicator used to display each self-diagnostic result. Refer to TM, "CONSULT Function".
• The self-diagnostic results indicated by the MI are automatically stored in both the ECM and TCM memories.

  Always perform the procedure on "How to Erase DTC" to complete the repair and avoid unnecessary blinking of the MI. Refer to TM, "Description".

  For details of OBD, refer to TM, "DIAGNOSIS DESCRIPTION : 1 Trip Detection Diagnosis and 2 Trip Detection Diagnosis".

• Certain systems and components, especially those related to OBD, may use the new style slide-locking type harness connector. For description and how to disconnect, refer to GI, "Description".

Preparation

Special service tools

*: The O-ring is a unit part and is set as a SST.

Commercial service tools

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "Seat belt pre-tensioner"

General Precautions

On Board Diagnosis (OBD) System of A/T and Engine

Removal and Installation Procedure for A/T Assembly Connector