Removal and Installation
REMOVAL
a. Remove steering column cover screws (A).
b. Tilt the steering column to the lowest position.
c. Pull steering column upper cover (1) upward to disengage steering column upper cover pawls.
: Pawl
d. Remove steering column upper cover.
e. Pull steering column lower cover (2) downward to remove.

INSTALLATION
Installation is in the reverse order of removal.
Instrument panel assemblyExploded View 1. Instrument side finisher (RH) 2. Passenger air bag module 3. Instrument panel assembly 4. Instrument side finisher (LH) 5. Ventilator grilles (LH) 6. Combination meter 7. C ...

Removal and Installation REMOVAL Remove steering column covers. Refer to IP "Removal and Installation". Remove cluster lid C. Refer to IP "Removal and Installation". Remov ...
Slip indicator lamp
Component Function Check
1.CHECK SLIP INDICATOR LAMP FUNCTION
Check that slip indicator lamp in combination meter turns ON for
approximately 2 seconds after ignition switch
is turned ON.
Is the inspection result normal?
YES >> Inspection End.
NO >> Proceed to diagnosis procedure. ...
Kicking plate inner
KICKING PLATE INNER : Removal and Installation
FRONT KICKING PLATE
Removal
1. Release front kicking plate pawls using a
suitable tool (A) and
remove front kicking plate as shown.
CAUTION:
Apply protective tape (B) to the body as shown before
releasing the pawl ...