TRUNK LID OPENER HANDLE : Removal and Installation
REMOVAL
1. Remove front kicking plate (LH). Refer to INT "KICKING PLATE INNER : Removal and Installation".
2. Release pawl using a suitable tool (A) and open the harness clip.
Pawl
3. Position floor carpet aside as necessary to access the trunk lid opener handle bolts.
4. Remove the trunk lid opener handle bolts.
5. Remove trunk lid opener cable from trunk lid opener handle.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
TRUNK LID LOCK : Removal and Installation REMOVAL 1. Remove trunk lid finisher (If equipped). Refer to INT "Removal and Installation". 2. Disengage rod holder (1) by lifting upward, and ...
TRUNK LID OPENER CABLE : Removal and Installation REMOVAL 1. Remove trunk lid striker. Refer to DLK "TRUNK LID STRIKER : Removal and Installation". 2. Remove trunk side finisher (LH). R ...
OD OFF indicator lamp
Component Function Check
1.CHECK OD OFF INDICATOR LAMP FUNCTION
Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YES >> INSPECTION END
NO >> Go to TM "Diagnosis Procedure".
Diagnosis Procedure
...
Body side welt
BODY SIDE WELT : Removal and Installation
CAUTION:
Do not excessively pull or stretch body side welts.
FRONT BODY SIDE WELT
Removal
Remove dash side finisher. Refer to INT "DASH SIDE FINISHER : Removal
and Installation".
Remove center pillar lower finisher. Refer to INT &quo ...