Nissan Versa (N17): Power supply, ground & circuit elements (PG)

Other materials:

Drive belt idler pulley
Exploded View 1. Generator bracket 2. Center shaft 3. Spacer 4. Adjusting bolt 5. Washer 6. Idler pulley 7. Plate Removal and Installation REMOVAL Remove the fender protector (RH). Remove the air duct inlet assembly. Remove drive belt. Remove the lock nut, and then remove the pl ...

Line pressure test
Work Procedure INSPECTION Check the engine oil level. Replenish if necessary. Refer to LU "Inspection". Check for CVT fluid leaks. Refer to TM "Inspection". Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to ...