Nissan Versa (N17): B2099 Ignition relay off stuck

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / Power control system (PCS) / B2099 Ignition relay off stuck

Description

  • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication.
  • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less.
  • Turn the ignition relay OFF with the following operation when the vehicle speed is more than 4 km/h (2.5 MPH) or when an abnormal condition occurs in CAN communication from the combination meter (Emergency OFF)
  • Press and hold the push-button ignition switch for 2 seconds or more.
  • Press the push-button ignition switch 3 times within 1.5 seconds.

NOTE: Ignition relay does not turn ON for 3 seconds after emergency OFF even if the push-button ignition switch is pressed.

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1. PERFORM SELF DIAGNOSTIC RESULT

1. Turn the ignition switch ON.

2. Erase "SELF-DIAG RESULTS".

3. Turn ignition switch OFF.

4. Turn the ignition switch ON. Check "SELF-DIAG RESULTS" again.

Is "IGN RELAY OFF" displayed?

YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

NO >> Refer to GI "Intermittent Incident".

B2098 Ignition relay on stuck

Description IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. Turn the ignition relay OFF by pressing the push-button igniti ...

Power supply and ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to PCS "Wiring Diagram". 1. CHECK FUSE AND FUSIBLE LINKS Check that the following IPDM E/R fuse or fusible links are not ...

Other materials:

Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift selector lever. Check that the selector lever position and the shift position indicator on the combination meter are identical. Is the inspection result normal? YES >> INSPECTION END N ...

Component parts
POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location 1. BCM (shown with instrument panel removed) 2. Front door switch LH 3. Front door lock actuator LH 4. Front door lock key cylinder switch LH 5. Front door switch RH 6. Front door lock actuator RH 7. Rear door sw ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0089