DTC DETECTION LOGIC 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
Is outside key antenna DTC detected?
YES >> Refer to DLK "Diagnosis Procedure".
NO >> Outside key antenna (rear bumper) is OK.
Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".
1.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> GO TO 2.
2.CHECK OUTSIDE KEY ANTENNA CIRCUIT


Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace harness.
3.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

Is the inspection result normal?
YES >> Replace outside key antenna (rear bumper).
NO >> Replace BCM. Refer to BCS "Removal and Installation".

Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown.&nb ...
Driver air bag module
Exploded View
1. Driver air bag module 2. Steering wheel
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
Before servicing, turn ignition switch OFF, disconnect both
battery terminals, then wait at least three
minutes or mor ...
Front pillar finisher
FRONT PILLAR FINISHER : Removal and Installation
REMOVAL
Release front pillar portion of front body side welt.
Pull front pillar finisher downward as shown, using mild pressure
to disengage the front pillar finisher from the clips.
: Clip
3. Remove the f ...