For additional information on brake fluid specification, refer to "Recommended fluids/lubricants and capacities" in the "Technical and consumer information" section of this manual.
WARNING
Old, inferior or contaminated fluid may damage the brake and clutch (if so equipped) systems. The use of improper fluids can damage the brake and clutch system and affect the vehicle's stopping ability.
CAUTION
Do not spill the fluid on any painted surfaces.
This will damage the paint. If fluid is spilled, immediately wash the surface with water.

Check the brake fluid level in the reservoir. If the fluid level is below the MIN line B , or the brake warning light comes on, add Genuine NISSAN Brake Fluid or equivalent DOT 3 fluid up to the MAX line A . If fluid must be added frequently, the system should be checked. It is recommended that you visit a NISSAN dealer for this service.

Check the fluid level in the reservoir. The brake fluid reservoir is shared with the clutch hydraulic system for manual transmissions. If the level is below the MIN line B , or the brake warning light comes on, add Genuine NISSAN Brake Fluid or equivalent DOT 3 fluid up to the MAX line A . If fluid must be added frequently, it is recommended that you visit a NISSAN dealer for servicing.
Power steering fluidCheck the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 32 to 86ºF (0 to 30ºC). The fluid level can be checked with ...

Windshield-washer fluid reservoir Add a washer solvent to the windshield-washer fluid reservoir for better cleaning. In the winter season, add a windshield-washer antifreeze. Follow the manufa ...
Door lock function
DOOR LOCK FUNCTION : System Description
SYSTEM DIAGRAM
DOOR REQUEST SWITCH OPERATION
When pressing the request switch, it is possible to lock and unlock the door
by carrying the Intelligent Key.
OPERATION DESCRIPTION
When the BCM detects that each door request switch is pressed, it s ...
Fuel filler lid lock
FUEL FILLER LID LOCK : Removal and Installation
REMOVAL
1. Fully open fuel filler lid.
2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER :
Removal and Installation".
3. Release pawls (A) and remove fuel filler lid lock assembly (1)
from opening.
CAUTION:
Be car ...