Exploded View

1. Front fog lamp bulb 2. Front fog lamp 3. Front bumper fascia 4. Front fog lamp finisher
REMOVAL
1. Remove the fender protector. Refer to EXT "Removal and Installation".
2. Disconnect the harness connector from the front fog lamp.
3. Remove the screws and front fog lamp.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After installation, perform fog lamp aiming adjustment procedure. Refer to EXL "Aiming Adjustment Procedure".
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
FRONT FOG LAMP BULB
Removal
1. Remove the fender protector. Refer to EXT "Removal and Installation".
2. Disconnect the harness connector (1) from front fog lamp bulb.
3. Rotate the bulb (2) counterclockwise and remove.

Installation
Installation is in the reverse order of removal.
CAUTION: After installing the bulb, install the bulb socket securely for watertightness.
Front combination lampExploded View 1. Front combination lamp (LH) ...

Exploded View 1. Combination switch 2. Combination switch harness connector Front Removal and Installation CAUTION: Before servicing, disconnect both battery terminals and wait at leas ...
Emission control system warranty
Your NISSAN vehicle is covered by the following
emission warranties:
For USA
1. Emission Defects Warranty
2. Emissions Performance Warranty
Details of this warranty may be found with other
vehicle warranties in your Warranty Information
Booklet which comes with your NISSAN vehicle.
If you ...
Fuel filler cap warning system
FUEL FILLER CAP WARNING SYSTEM : System Diagram
FUEL FILLER CAP WARNING SYSTEM : System Description
INPUT/OUTPUT SIGNAL CHART
Input
Unit/Sensor
Input signal to ECM
ECM function
EVAP control system pressure sensor
Pressure in purge line
Fuel filler cap warning cont ...