Nissan Versa (N17): C1120, C1122, C1124, C1126 ABS In valve system

Nissan Versa 2nd generation (N17) Service Manual / Brakes / Brake control system (BRC) / C1120, C1122, C1124, C1126 ABS In valve system

DTC Logic

DTC DETECTION LOGIC   

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

  1. Turn ignition switch ON.
  2. Perform self diagnostic result.

Is DTC C1120, C1122, C1124 or C1126 detected?

YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to BRC "Wiring Diagram".

1.CONNECTOR INSPECTION

  1. Turn ignition switch OFF.
  2. Disconnect ABS actuator and electric unit (control unit) connector.
  3. Check connector and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES >> GO TO 2

NO >> Repair or replace as necessary.

2.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) BATTERY POWER SUPPLY

Check voltage between ABS actuator and electric unit (control unit) connector E33 terminal 25 and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace malfunctioning components.

3.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) GROUND CIRCUIT

Check continuity between ABS actuator and electric unit (control unit) connector E33 terminals 13, 38 and ground.               

Is the inspection result normal?

YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".

NO >> Repair or replace malfunctioning components.

Other materials:

P0717 Input speed sensor A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0717 Input/Turbine Speed Sensor "A" Circuit No Signal Under the following diagnosis conditions, the input speed sensor value is less than 600 rpm continuousl ...

Low tire pressure warning lamp blinks
Diagnosis Procedure NOTE: If low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds, wake-up operation for all transmitters is not complete. Carry out transmitter wake-up operation. Refer to WT "Work Procedure". 1.CHECK BCM CONNECTOR Turn igniti ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0066