Nissan Versa (N17): C1130 Engine signal

DTC Logic

DTC DETECTION LOGIC           

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

  1. Turn ignition switch ON.
  2. Perform self diagnostic result.

Is DTC C1130 detected?

YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK SELF DIAGNOSTIC RESULT FOR ENGINE SYSTEM

With CONSULT.

Perform self diagnostic result. Refer to EC "CONSULT Function".

Are any ECM DTCs detected?

YES >> Refer to EC "DTC Index".

NO >> GO TO 2.

2.CHECK SELF DIAGNOSTIC RESULT FOR ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

With CONSULT.

  1. Perform self diagnostic result and erase DTCs.
  2. Turn ignition switch OFF.
  3. Start engine and drive vehicle for a short period of time.
  4. Check that malfunction indicator lamp (MIL) turns OFF.
  5. Stop vehicle and perform self diagnostic result.

Is DTC C1130 detected?

YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".

NO >> Check pin terminals and connection of connectors for abnormal conditions. Repair or replace malfunctioning components.

Other materials:

Readiness for inspection/maintenance (I/M) test
Due to legal requirements in some states and Canadian Provinces, your vehicle may be required to be in what is called the "ready condition" for an Inspection/Maintenance (I/M) test of the emission control system. The vehicle is set to the "ready condition" when it is driven through certain d ...

Malfunction indicator lamp
Component Function Check 1.CHECK MIL FUNCTION Turn ignition switch ON. Make sure that MIL lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Go to EC, "Diagnosis Procedure". Diagnosis Procedure 1.CHECK DTC Check that DTC UXXXX is not display ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0066