1. CANCEL switch
2. ACCEL/RES switch
3. COAST/SET switch
4. CRUISE ON/OFF switch
WARNING
Do not use the cruise control when driving under the following conditions:
Doing so could cause a loss of vehicle control and result in an accident.
CAUTION
On manual transmission models, do not shift into N (Neutral) without depressing the clutch pedal when the cruise control is set. Should this occur, depress the clutch pedal and turn the main switch off immediately.
Failure to do so may cause engine damage.
The cruise control allows driving at a speed between 25 - 89 mph (40 - 144 km/h) without keeping your foot on the accelerator pedal.
To turn on the cruise control, push the CRUISE ON/OFF switch. The CRUISE indicator light in the instrument panel comes on.
To set cruising speed, accelerate the vehicle to the desired speed, push the COAST/SET switch and release it. The CRUISE indicator light in the instrument panel comes on. Take your foot off the accelerator pedal. Your vehicle maintains the set speed.
To cancel the preset speed, use one of the following three methods.
The cruise control is automatically canceled and the CRUISE light in the instrument panel goes out if:
To reset at a faster cruising speed, use one of the following three methods.
When the vehicle attains the speed you desire, release the switch.
Each time you do this, the set speed increases by about 1 mph (1.6 km/h).
To reset at a slower cruising speed, use one of the following three methods.
Each time you do this, the set speed decreases by about 1 mph (1.6 km/h).
To resume the preset speed, push and release the ACCEL/RES switch. The vehicle returns to the last set cruising speed when the vehicle speed is over 25 mph (40 km/h).
WARNING Be sure the parking brake is fully released before driving. Failure to do so can cause brake failure and lead to an accident. Do not release the parking brake from outside the ve ...
CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to fo ...
Rear suspension beam
Exploded View
1. Rear suspension beam
Removal and Installation
REMOVAL
Remove the wheel and tire assemblies using power tool. Refer to WT
"Adjustment".
Remove wheel sensor and sensor harness. Refer to BRC "REAR WHEEL SENSOR
: Removal and
Installation".
Re ...
Trunk open function
TRUNK OPEN FUNCTION : System Description
System Diagram
TRUNK LID OPENER OPERATION
When the BCM detects that trunk lid opener switch is pressed, it starts
the outside key antenna (rear
bumper) and inside key antenna and transmits the request signal to the
Intelligent Key. Then, c ...