Security indicator lamp does not blink when power supply position is other than the ON position.
NOTE:
Conditions of Vehicle (Operating Conditions) Power supply position is other than the ON position.
1.CHECK SECURITY INDICATOR LAMP
Check security indicator lamp.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES >> Check intermittent incident. Refer to GI"Intermittent Incident".
NO >> GO TO 1.
REMOVAL AND INSTALLATION

Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP"Removal and Installation". 2. Release the NATS antenna amp. pawls and remove NATS antenna amp. (1) ...
Ignition coil, spark plug and rocker cover
Exploded View
1. Ignition coil 2. Spark plug 3. Rocker cover
4. Hose cramp 5. PCV hose 6. PCV valve
7. Oring 8. Gasket 9. Oil filler cap
10. Oring 11. Intake camshaft position sensor 12. Exhaust camshaft position
sensor
13. Clip A. To intake manifold
Removal and Installation
REMOVAL
...
Main power supply and ground circuit
Diagnosis Procedure
1.CHECK TCM POWER CIRCUIT 1
Turn the ignition switch OFF.
Disconnect the TCM connector.
Check the voltage between the TCM harness connector terminals and
ground.
Is the inspection result normal?
YES >> GO TO 2.
NO >> GO TO 4.
2.CHECK TCM POWER ...