DISC ROTOR : Inspection and Adjustment
INSPECTION
Appearance
Check surface of disc rotor for uneven wear, cracks, and serious damage. Replace it if necessary. Refer to BR "DISC ROTOR : Inspection and Adjustment".
Runout
Refer to FAX "Inspection".
Runout (with it attached to the vehicle) : Refer to BR "Front Disc Brake".
CAUTION: If the thickness is less than wear thickness + 0.3 mm (0.012 in), replace the disc rotor. Refer to BR"BRAKE CALIPER ASSEMBLY : Removal and Installation".
Wear thickness : Refer to BR "Front Disc Brake".
Thickness
Check the thickness of the disc rotor using a micrometer. Replace the disc rotor if the thickness is below the wear limit. Refer to BR "Front Disc Brake".
Wear thickness : Refer to BR "Front Disc Brake".
Thickness variation (measured at 8 positions) : Refer to BR "Front Disc Brake".
ADJUSTMENT
Burnish contact surfaces between disc rotors and brake pads according to the following procedure after refinishing or replacing disc rotor, or if a soft pedal occurs at very low mileage.
CAUTION:
REAR DRUM BRAKE
BRAKE PAD : Inspection and Adjustment INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR "F ...
BRAKE LINING : Inspection and Adjustment INSPECTION Brake Lining Remove plug from back plate. Refer to BR "Exploded View". Check brake lining wear thickness (A) from an inspection ho ...
EVAP canister
Exploded View
1. EVAP control system pressure sensor 2. O-ring 3. EVAP canister
4. Hose clamp 5. EVAP canister purge hose 6. EVAP vent line
7. O-ring 8. EVAP canister vent control valve 9. EVAP canister vent control
valve
hose
A. Mount to vehicle bracket
Removal and Installation
NOTE: ...
O/D OFF indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YES >> INSPECTION END
NO >> Go to TM "Diagnosis Procedure".
Diagnosis Procedur ...