Exploded View
1. Strut assembly 2. Coil spring 3. Bound bumper 4. Spring upper seat 5. Strut mounting bearing 6. Piston rod lock nut 7. Strut mounting insulator 8. Stopper insulator 9. Stopper insulator lock nut
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Do not reuse stopper insulator lock nut.
DISASSEMBLY
CAUTION: Do not damage strut assembly piston rod when removing components from strut assembly.
Tool number : ST35652000 ( - )
CAUTION: When installing the Tool to strut assembly, wrap a shop cloth around strut to protect from damage.
CAUTION: Be sure the tool is securely attached to the coil spring before compressing coil spring.
CAUTION: Loosen while making sure coil spring attachment position does not move.
Tool number : ST35652000 ( - )
9. If necessary, remove strut mounting bearing (1) from spring upper seat (2), using a Tool (A).
Tool number : KV10106700 ( - )
CAUTION: Do not disassemble the strut mounting bearing unless damage exists.
10. Perform inspection after disassembly. Refer to FSU "Inspection and Adjustment".
INSPECTION AFTER DISASSEMBLY
Strut Inspection
Check the following:
Strut Mounting Insulator and Rubber Parts Inspection
Check strut mounting insulator for cracks and rubber parts for wear. Replace it if malfunction is detected.
Coil Spring Inspection
Check coil spring for cracks, wear or damage, and replace it if necessary.
ASSEMBLY
1. Install Tool (A) to strut and secure it in a vise.
Tool number : ST35652000 ( - )
CAUTION: When installing the strut attachment to strut assembly, wrap a shop cloth around strut to protect from damage.
2. Apply soapy water to bound bumper.
CAUTION: Do not use machine oil.
3. Insert bound bumper into spring upper seat.
4. Compress coil spring using a spring compressor (commercial service tool), and install it onto strut assembly.
CAUTION:
Compress coil spring.
5. Install strut mounting bearing, spring upper seat, and bound bumper as a set.
6. Secure piston rod tip so that piston rod does not turn, then tighten piston rod lock nut with specified torque.
7. Gradually release a spring compressor, and remove coil spring.
CAUTION: Loosen while making sure coil spring attachment position does not move.
8. Remove the Tool (A) from strut assembly.
Tool number : ST35652000 ( - )
9. Install strut mounting insulator.
CAUTION:
NOTE:
(A) : 20 - 30 mm (0.79 - 1.18 in)
3. Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION: Dispose of drained oil according to the law and local regulations.
Inspection and Adjustment INSPECTION Make sure the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. LOWER BALL JOINT END PLAY ...
Exploded View 1. Front suspension member 2. Transverse link Removal and Installation REMOVAL Remove the wheel and tire assembly using power tool. Refer to WT "Adjustment". ...
Shift lock system
SHIFT LOCK SYSTEM : Component Parts Location
1. Stop lamp switch 2. Shift lock release lever 3. Park position switch
4. Shift lock solenoid
Component
Function
Stop lamp switch
Stop lamp switch turns ON when brake pedal is depressed
Shift lock release lever
Ma ...
Air breather hose
Removal and Installation
REMOVAL
Remove air duct (inlet). Refer to EM "Exploded View".
Remove air breather hose from transaxle assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Check that air breather hose is not collapsed or blocked due to ...