CAUTION:
REMOVAL
1. Remove front door harness grommet (1) and then pull out the harness from the vehicle (2).
2. Disconnect the harness connectors (A) from front door assembly.
3. Remove door check link bolt (body side).
4. Remove door hinge nuts (door side) and front door assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
1. Front fender 2. Front door 3. Rear door 4. Body side outer 5. Door striker 6. Striker bolt 7. Front door hinge 8. Rear door hinge (upper) 9. Rear door hinge (lower)
Check the clearance and surface height between front door and each part by visual inspection and tactile feel.
If the clearance and the surface height are out of specification, adjust them
according to the adjustment procedure.
ADJUSTMENT PROCEDURE
CAUTION:
Check door hinge rotating point for poor lubrication. If necessary, apply a suitable multi-purpose grease.
After adjusting, apply touch-up paint (body color) onto the heads of hinge bolts and nuts.
8. Install front fender. Refer to refer to DLK "FRONT FENDER : Removal and Installation".
DOOR STRIKER ADJUSTMENT
Adjust door striker so that it becomes parallel with door lock insertion direction.
DOOR STRIKER
DOOR STRIKER : Removal and Installation
REMOVAL
Remove striker bolts and front door striker.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
FENDER COVER : Removal and Installation REMOVAL 1. Fully open hood assembly. 2. Disengage pawls beginning at the front of the fender cover and working toward the rear of vehicle and then remove fr ...
DOOR HINGE : Removal and Installation REMOVAL CAUTION: Use two people when removing or installing front door due to its heavy weight When removing and installing front door assembly, supp ...
Front pillar finisher
FRONT PILLAR FINISHER : Removal and Installation
REMOVAL
Release front pillar portion of front body side welt.
Pull front pillar finisher downward as shown, using mild pressure
to disengage the front pillar finisher from the clips.
: Clip
3. Remove the f ...
Trunk rear plate
TRUNK REAR PLATE : Removal and Installation
REMOVAL
Fully open trunk lid.
Remove trunk floor carpet.
Remove trunk rear plate clips (A).
4. Release trunk rear plate pawls using a
suitable tool (A) and
remove trunk rear plate as shown.
INSTALLATION
...