Nissan Versa (N17): Door check link

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Door check link

DOOR CHECK LINK : Removal and Installation

REMOVAL

  1. Fully close the front door window.
  2. Remove front door finisher. Refer to INT "Removal and Installation".
  3. Remove front door speaker bolts.
  4. Disconnect harness connector from front door speaker and remove.
  5. Remove door check link bolt from body.
  6. Remove door check link bolts on door panel.
  7. Remove door check link (1) through the hole in door panel (2).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • After installation, check rear door open/close operation.
  • Check door check link rotating point for poor lubrication. If necessary, apply a suitable multi-purpose grease.

INSTALLATION

REAR DOOR

Exploded View

Exploded View

1. Rear door panel 2. Grommet 3. Striker bolt 4. Door striker 5. Bumper rubber 6. Sealing screen (lower) (without door speaker) 7. Door check link 8. Door hinge (lower) 9. Door hinge (upper)

Door hinge

DOOR HINGE : Removal and Installation REMOVAL CAUTION: Use two people when removing or installing front door due to its heavy weight When removing and installing front door assembly, suppor ...

Door assembly

Other materials:

Thermostat
Exploded View 1. Radiator hose (lower) 2. Water inlet 3. Rubber ring 4. Thermostat A. To radiator Removal and Installation WARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from highpressure engine coolant escaping from the radiator. Wrap a thick cl ...

Evaporative emission system
EVAPORATIVE EMISSION SYSTEM : System Diagram EVAPORATIVE EMISSION SYSTEM : System Description INPUT/OUTPUT SIGNAL CHART Sensor Input signal to ECM ECM function Actuator Crankshaft position sensor (POS) Camshaft position sensor (PHASE) Engine speed*1 Piston ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0048