Nissan Versa (N17): Door lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Door lock

DOOR LOCK : Removal and Installation

REMOVAL

  1. Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and Installation".
  2. Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
  3. Disconnect the harness connector from the door lock actuator.
  4. Remove front door lower sash (rear). Refer to INT "Exploded View".
  5. Remove door lock assembly bolts and door lock assembly.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse door lock assembly bolt. Always replace it with a new one when it is removed.
  • After installation, check door open/close, lock/unlock operation.
  • Check door lock cable is properly engaged with outside handle bracket.
  • Check door lock assembly for poor lubrication. Apply a suitable multi-purpose grease to door lock if necessary.

INSTALLATION

Hood lock secondary control

HOOD LOCK SECONDARY CONTROL : Removal and Installation REMOVAL Remove radiator upper seal clips and then remove upper clip from radiator side seal (RH). Refer to DLK "Exploded View" ...

Inside handle

INSIDE HANDLE : Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT "Removal and Installation". 2. Remove upper side of sealing screen. NOTE: Cut the butyl tape ...

Other materials:

Mixture ratio selflearning value clear
Description This describes how to erase the mixture ratio selflearning value. For the actual procedure, follow the instructions in "Diagnosis Procedure". Work Procedure 1.START With CONSULT Start engine and warm it up to normal operating temperature. Select "SELFLEARNING CONT" in "WOR ...

Ignition timing
Inspection 1.CHECK IGNITION TIMING     1.   Attach timing light (A) to loop wire (1) as shown.     2.   Check ignition timing. 1 : Timing indicator >> INSPECTION END ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.005