Nissan Versa (N17): Door outside molding

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Exterior (EXT) / Door outside molding

Exploded View

Exploded View

1. Front door panel 2. Rear door panel 3. Front door outside molding 4. Rear door outside molding Pawl

Removal and Installation

FRONT DOOR OUTSIDE MOLDING

Removal

1. Open front door glass.

2. Release pawl, twist front door outside molding toward the outside of the vehicle and lift up and remove.

Installation

Installation is in the reverse order of removal.

REAR DOOR OUTSIDE MOLDING

Removal

1. Open door glass.

2. Release pawl, twist door outside molding toward the outside of the vehicle and lift up and remove.

Installation

Installation is in the reverse order of removal.

Roof side molding

Exploded View 1. Roof side molding 2. Roof side molding clip 3. Roof panel 4. Body side outer panel Removal and Installation REMOVAL 1. Release roof side molding clip using a suitable tool ...

Trunk lid finisher

Exploded View 1. Trunk lid finisher 2. Emblem 3. Rear view camera (if equipped) Pawl Clip Removal and Installation REMOVAL 1. Remove trunk lid finisher inner. Refer to INT "Removal and ...

Other materials:

U1117 Lost communication (ABS)
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U1117 Lost Communication With ABS When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ABS actuator control unit cont ...

Rear suspension beam
Exploded View 1. Rear suspension beam Removal and Installation REMOVAL Remove the wheel and tire assemblies using power tool. Refer to WT "Adjustment". Remove wheel sensor and sensor harness. Refer to BRC "REAR WHEEL SENSOR : Removal and Installation". Re ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0092