Exploded View

1. Trunk lid finisher 2. Emblem 3. Rear view camera (if equipped)
Pawl
Clip
Removal and Installation
REMOVAL
1. Remove trunk lid finisher inner. Refer to INT "Removal and Installation".
2. Remove trunk lid finisher nuts.
3. Disconnect the harness connectors from the license lamp.
4. Remove harness grommet.
5. Release clips and remove trunk lid finisher.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: When installing trunk lid finisher, check that clips are securely placed in body panel holes and press them into position.
Door outside moldingExploded View 1. Front door panel 2. Rear door panel 3. Front door outside molding 4. Rear door outside molding Pawl Removal and Installation FRONT DOOR OUTSIDE MOLDING Removal 1. Open fro ...

Exploded View 1. Door parting seal 2. Double-sided tape [t: 1.6 mm (0.065 in)] Clip Removal and Installation REMOVAL 1. Open front door and rear door. 2. Release door parting seal clips usi ...
If your vehicle overheats
If your vehicle is overheating (indicated by an
extremely high temperature gauge reading (if so
equipped), a red high temperature warning light
(if so equipped) ), or if you feel a
lack of
engine power, detect abnormal noise, etc. take
the following steps.
WARNING
Do not continue to driv ...
Variable voltage control system (if so equipped)
CAUTION
Do not ground accessories directly to
the battery terminal. Doing so will bypass
the variable voltage control system
and the vehicle battery may not
charge completely.
Use electrical accessories with the engine
running to avoid discharging the
vehicle battery.
Your v ...