Nissan Versa (N17): B2628 Outside antenna

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / B2628 Outside antenna

DTC Logic

DTC DETECTION LOGIC 

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Check Self Diagnostic Result mode of BCM using CONSULT.

Is outside key antenna DTC detected?

YES >> Refer to DLK "Diagnosis Procedure".

NO >> Outside key antenna (rear bumper) is OK.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".

1.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

  1. Turn ignition switch ON.
  2. Check signal between BCM harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> GO TO 2.

2.CHECK OUTSIDE KEY ANTENNA CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect BCM connector and outside key antenna (rear bumper) connector.
  3. Check continuity between BCM harness connector and outside key antenna (rear bumper) harness connector.             
  4. Check continuity between BCM harness connector and ground.   

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness.

3.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

  1. Replace outside key antenna (rear bumper). (New antenna or other antenna)
  2. Connect BCM and outside key antenna (rear bumper) connector.
  3. Turn ignition switch ON.
  4. Check signal between BCM harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> Replace outside key antenna (rear bumper).

NO >> Replace BCM. Refer to BCS "Removal and Installation".

Power supply and ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown.&nb ...

Other materials:

Standard maintenance
The following tables show the standard maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits and vehicle usage, additional or more frequent maintenance may be required. After 120,000 miles (192,000 km)/144 months, continue m ...

Dash side finisher
DASH SIDE FINISHER : Removal and Installation REMOVAL Remove front kicking plate. Refer to INT "KICKING PLATE INNER : Removal and Installation". Lift up rear end of dash side finisher to disengage metal clip. : Metal clip     3.   Pull back dash sid ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0113