DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press door request switch.
2. Turn ignition switch ON.
3. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.
Is DTC detected?
YES >> Go to SEC "Diagnosis Procedure".
NO >> Inspection End.
1.INSPECTION START
1. Turn ignition switch ON.
2. Select Self Diagnostic Result mode of BCM using CONSULT.
3. Touch ERASE.
4. Perform DTC CONFIRMATION PROCEDURE for DTC B26F7. Refer to SEC "DTC Logic".
Is DTC B26F7 detected again?
YES >> GO TO 2.
NO >> Inspection End.
2.REPLACE BCM
1. Replace BCM. Refer to BCS"Removal and Installation".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.
>> Inspection End.
Radiator core support lower
RADIATOR CORE SUPPORT LOWER : Removal
and Installation
Removal
1. Remove under cover. Refer to EXT "Removal and Installation".
2. Remove radiator upper seal clips.
3. Remove front bumper fascia upper side clips (A).
4. Remove fender protector (LH/RH) clips from radiator core suppor ...
Trunk lid finisher
Exploded View
1. Trunk lid finisher 2. Emblem 3. Rear view camera (if equipped)
Pawl Clip
Removal and Installation
REMOVAL
1. Remove trunk lid finisher inner. Refer to INT "Removal and Installation".
2. Remove trunk lid finisher nuts.
3. Disconnect the harness connectors from ...