Nissan Versa (N17): B210B Starter control relay

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B210B Starter control relay

DTC Logic

DTC DETECTION LOGIC

NOTE: If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".           

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press push-button ignition switch under the following conditions to start engine, and wait 1 second or more.

  • Selector lever: In the P position
  • Brake pedal: Not depressed

2. Check DTC in Self Diagnostic Result mode of IPDM E/R using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC FOR BCM

Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Perform the trouble diagnosis related to the detected DTC. Refer to BCS "DTC Index".

NO >> GO TO 2.

2.INSPECTION START

1. Turn ignition switch ON.

2. Select Self Diagnostic Result mode of IPDM E/R using CONSULT.

3. Touch "ERASE".

4. Perform DTC CONFIRMATION PROCEDURE for DTC B210B. Refer to SEC "DTC Logic".

Is DTC detected?

YES >> GO TO 3.

NO >> Inspection End.

3.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B210B. Refer to SEC "DTC Logic".

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

Other materials:

Bluetooth Hands-Free Phone System without Navigation System (Type B) (if so equipped)
WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. If you are unable to devote full attention to vehicle operation while talking on ...

Output speed sensor
Exploded View 1. Transaxle assembly 2. Output speed sensor 3. O-ring Front Genuine NISSAN CVT Fluid NS-3 Removal and Installation REMOVAL Disconnect the harness connector from output speed sensor. NOTE: Lift up the vehicle and perform the work from rear of the transaxle asse ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0084