Exploded View

1. Front grille 2. Front emblem
Pawl
Removal and Installation
REMOVAL
1. Remove front bumper fascia. Refer to EXT "Removal and Installation".
2. Remove front grille nuts (A).
3. Pull front grille out away from vehicle to disengage pawls and then remove front grille.
: Pawl

4. Remove front emblem from front grille (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Rear bumperExploded View 1. Rear bumper side brackets (LH) 2. Rear bumper closing (LH) 3. Rear bumper fascia 4. Rear bumper closing (RH) 5. Rear bumper side brackets (RH) 6. Rear bumper reinforcement ...

Exploded View 1. Cowl top cover seal 2. Cowl top cover 3. Air intake cover 4. Cowl cover one-way valve 5. Washer nozzle 6. EPT sealer [3.0 mm (0.118 in)] 7. EPT sealer [3.0 mm (0.118 in)] Clip ...
Front wiper motor ground circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW "Wiring Diagram".
1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect front wiper motor.
3. Check continuity between front wiper motor harness connector and ground.
Is the inspe ...
Diagnosis system (IPDM E/R)
Diagnosis Description
AUTO ACTIVE TEST
Description
In auto active test, the IPDM E/R sends a drive signal to the following
systems to check their operation.
Front wiper (LO, HI)
Parking lamp
License plate lamp
Tail lamp
Front fog lamp
Headlamp (LO, HI)
A/C compressor (magnet c ...